1.25" Pool Hose Coupler
Derek Tombrello · MyMiniFactory
Lisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
When you need a coupler to connect two 1¼" pool hoses together on a weekend out in the sticks and every hardware store is closed.... you print one :) This quick little print only takes about an hour with a 0.3mm layer height and a 60mm/sec print speed. This is a snug fit and since I'm just using this on the waste side, I didn't bother with clamps, but if you are using it on either the inlet or output of the pump, I'd recommend clamps around the hoses. ---Another Sketchup Model - Debunking the M…
♥ 12
MyMiniFactory'da aç