1:64 Winners Trophy Cup - Race Diorama | No Supports

A winner cup on a stepped base. The bowl flares out at 45 degrees from the stem, so the whole cup prints with no support. Made for **1:64 scale diecast cars** - the small toy car size, about **68 x 28 mm**. - Car slot is **70 x 32 mm**, so every 1:64 car fits with room to spare - Two wheel stops in every car dish, so nothing rolls off - **No supports anywhere** - every roof inside is a 45-degree tent or a pointed arch - Prints flat on the bed, no raft and no brim needed - Original design: no ca…

♥ 0