10'' Generative FPV Drone Frame

Description This frame has not yet been flight-tested. If you tested it, please share your feedback, flight experience, and suggestions for improvements in the comments. The frame was designed using generative design , with the goal of achieving a good balance between low weight, high stiffness, and efficient material usage while remaining printable on a consumer 3D printer. Compatibility Flight Controller 20 x 20 mm FPV stack 30.5 x 30.5 mm FPV stack VTX 20 x 20 mm (M2) — small VTX mounts, fit…

♥ 0