printedworks
Airsoft Kriss Vector Full Length Rail Riser - 30mm

Airsoft Kriss Vector Full Length Rail Riser - 30mm

Jeremy S Caylor · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

I liked the look of the 30mm swept rail on Thingiverse by DNeves, so I extended it to fit on my KWA Vector. I slightly enlarged the picatinny slot as it was a quite a tight fit and I also enlarged the top rail portion a few percent as it was a bit too small. The rear portion (30mm) of the Vector's rail was left open to allow the sling mount to move freely and not get obstructed by the rail. This version has countersinks for square M3 nuts (I had a bunch left over from a kit), but I will upload…

♥ 183

MyMiniFactory'da aç

Benzer modeller