
Anet A6 Stabilising Struts and Base Clamp
Cameron · MyMiniFactory
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
These struts are designed to stabilise the Anet A6 and to prevent it moving on its bench. I found that after adding more tension to the Y Belt that the whole printer would "flex" forward. To fix this I added these 8mm threaded struts which keep the frame square and hold the printer in the correct position at all times. These have saved me a fair bit of bed levelling by stabilising the positions of the uprights relative to the Y axis front belt plate. Each 8mm threaded strut is about 40cm long b…
♥ 4
MyMiniFactory'da açBenzer modeller

2040 Aluminum Frame Support brackets for Anet AM8
Printables

ANet A8 X axes stopper for the E3D V6 Minimal Extruder
Printables

Fan Baffle for Ender 3 Mainboard Enclosure on Anet A8 Plus
Printables

Anet AM8 BLV Gantry Adapter Hero Me Gen 7 Release 4 (HMG7.4)
Printables

220 * 220 Heatbed Stress Relief (I used this for my Anet A8)
Printables

Fixed BL-Touch Anet A8 Direct drive mount
Printables

Anet A8 Y Limit Switch Holder
Printables

Anet A8 Mostfet V1 holder
Printables

2020 frame 7 Inch Offical Pi Touchscreen mount
Printables

Anet A8 two Switch case
Printables

Anet A8 fan duct extensor
Printables

Anet A6 Front Plate for Y Rods and Belt.
Printables