Angled Bones - Pen Blank Mould for Resin

Ready to print mould for pen turning, Resin cast is 25 x 25 x 150, Cast with your preferred resin, You can cast the different sections with a different colour with carful use of a syringe, Drill fast with a sharp bit and clear out regular, If printed in PLA try to not let it heat up too much, You can cut the external "mould" off prior to turning but PLA turns off easy enough, Turn as usual with resin, I prefer to fast - wet sand resin but again, if printed in PLA try not to let sanding warm up…

♥ 0