printedworks
Cap Peg – Wall Hook for Baseball Caps, Keeps the Shape

Cap Peg – Wall Hook for Baseball Caps, Keeps the Shape

Layerline · Cults3D

ÜcretsizCC BY-NC - Attribution - Non commercial
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This is a wall peg for baseball caps: hang the cap by the opening at the back over the peg – the dome keeps the crown in shape. Screw it to the wall with two screws. - Plate Ø 50 mm, peg 40 mm with a Ø 30 mm dome - Prints on its back, peg up – no supports This is the free basic version. The complete set is "Cap Rack – Wall Peg, 4-Peg Rail and Over-Door Hanger for Baseball Caps" – you'll find it in the Layerline shop on Cults3D.

♥ 0

Cults3D'da aç

Benzer modeller