Chicken Waterer for 1-Gallon Jug v2 - 786 mL Open Trough, 7 Birds at Once, No Supports
UndercoverBrother · Cults3D
Ticari kullanım: izinli görünmüyorLisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
A gravity chicken waterer built around a 1-gallon jug you already have. Take the cap off, stand the jug mouth-down in the middle, and the pan around it stays topped up on its own. **THE WHOLE BASE IS THE TROUGH** There is no little bowl off to one side. The pan is one open vessel, so the water is a single body at a single level, and the birds drink from the ring around the outside of the jug, where nothing is overhead. - **786 mL of standing water** in the 202 mm version, 1.23 L in the 250 mm o…
♥ 0
Cults3D'da açBenzer modeller

Chicken Waterer
Printables

Semi-Parametric front rail 3d printer gantry
Printables
110mm Pipe End Caps (+one for chicken feeders)
Thingiverse

esun spool black reuse conversion
Printables

Chicken Foot Prosthetic
Thingiverse

hen 3d model
Sketchfab

rooster 3d model
Sketchfab

raw chicken wing 3d model
Sketchfab

fried chicken drumstick 3d model
Sketchfab

whole raw chicken 3d model
Sketchfab
/https://fbi.cults3d.com/uploaders/31864757/illustration-file/40284f60-96f0-4973-9f37-d17781c7f49d/chica-the-chicken-fortnite-figure-3d-print-cover.png)
Chica the Chicken FNAF Inspired SKIN FORTNITE FIGURE
Cults3D

⭐ Chicken Jockey!
Sketchfab