Dome knob with hex nut pocket M8 - clamping knob, 4 sizes 25/30/36/44 mm, no supports

A dome over a knurled band. The dome is deliberately flatter than a hemisphere: a true half-sphere would print at 65 degrees of overhang and need supports. Takes a DIN 934 hex nut M8 from the back - the thread is steel, not printed plastic, so it survives being done up hard. The bolt runs right through, so its length does not matter. M8 is the machine-table size: clamps, stops, anything that must not shift under a cut. ## Sizes in the download All 4 diameters, same shaft fitting: | Diameter | H…

♥ 1