Double Towel Hook – reinforced, 2 screws, wall mount, prints flat, no supports

Reinforced double hook for towels or a bathrobe. Prints flat against the build plate (the face that mounts on the wall lies on the bed), so the 45° hook arms need no supports. - Two 45°-angled hooks, 18 mm wide each, spaced clear of the mounting screws - Two countersunk M4/M5 screw holes (4.5 mm shaft, 9 mm countersink), well clear of the hooks - Body 90 × 60 × 7 mm plus the hook arms — fits a 220 × 220 mm bed easily - About 1 h print time, ~25 g (PLA, 20 % infill recommended for load-bearing)…

♥ 0