Dresser drawer pull

This was created to replace a missing drawer pull on a vintage dresser. For best results, print with the back face (the side against the dresser drawer) down. The hole is pre-threaded, no need for tapping. Configurations currently available: 2 holes, 25.3mm apart, pre-threaded for (I think) M4 x 0.7 2 holes, 32mm apart, pre-threaded for M3 x 0.5 If you'd like a different thread/hole configuration, leave a comment or send me a message and I'll get it added for you. -- If you like my work and wan…

♥ 0