Дельфин Flaxi

The movable Flaxi dolphin. Recommendations for printing with PLA This plastic is easier to work with. Temperature. Nozzle: approximately 190–220 °C. Build plate: you can print without heating, but if you do heat it, use 50–60 °C. PETG This material is stronger and more resistant to moisture, but it requires a slightly more fine‑tuned setup. Temperature. Nozzle: 220–250 °C (often the starting point is 240 °C). Build plate: 70–85 °C (heating is mandatory to prevent the lower layers from peeling o…

♥ 0