printedworks
Flysky / Turnigy i6 Stick Protector (friction fit)

Flysky / Turnigy i6 Stick Protector (friction fit)

Jude Robinson · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

WARNING - to get a good friction fit I designed the hole a bit too small so for best results sand down the inner diameter until it fits. This is designed for flysky and turnigy i6 controllers and holds the sicks in place as well as protecting them from getting hit and damaged. I wanted to design a stick protector that didn't take up the lanyard loop so instead it uses a friction fit. This means you might have to sand the inside, I found that pencils have the right diameter so if you glue sandpa…

♥ 1

MyMiniFactory'da aç

Benzer modeller