printedworks
Guitar String Winder – Crank with Spinning Knob and Bridge Pin Puller

Guitar String Winder – Crank with Spinning Knob and Bridge Pin Puller

Layerline · Cults3D

ÜcretsizCC BY-NC - Attribution - Non commercial
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This is a string winder for guitars: put the slot over the tuning key and crank – a new set of strings goes on in minutes. The knob spins freely on its pin, and the notch at the end of the arm lifts stuck bridge pins on acoustic guitars. - Slot 7 × 24 mm with a lead-in, fits most guitar tuning keys - Arm 70 mm; winder and knob on one plate - The winder prints with the slot on the bed, the knob upright – no supports This is the free basic version. The complete set is "Guitar String Winders – Sta…

♥ 0

Cults3D'da aç

Benzer modeller