printedworks
Hexagonal 40mm fan grill

Hexagonal 40mm fan grill

Hassan Helal · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

Most of the fan grills i could find had the grill too close to the fan blades which increased noise, had holes that were too big or just too flashy, so i had to make my own. A couple of hexagons later and here we are... The shroud extends 10mm from the face of the fan. This thing is made to be a snug fit for a 5.5-6mm diameter hole even with a screw in it* One stl has a chamfered face (chmf), the other one doesn't. I would use the chamfered one if I were you. *your mileage may vary, a crappy SW…

♥ 13

MyMiniFactory'da aç

Benzer modeller