printedworks
Hexagonal Dice Box with magnets

Hexagonal Dice Box with magnets

Nicholas · MyMiniFactory

ÜcretsizCreative Commons - Attribution - Noncommercial - ShareAlike
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

Inspired by the hexagonal dice box by Nerys on thingiverse, I wanted a dice box that both top and bottom were identical, and which would stack with other dice. I settled on using 5mm sphere magnets. There are 3 pockets toward the bottom and six pockets toward the top of the the part. I modify the gcode by adding the M600 command before layer 33 and layer 67 (0.2mm layer height) to do a filament swap. This pauses the printer, removes the filament from the hot end, and waits for me to drop magnet…

♥ 129

MyMiniFactory'da aç

Benzer modeller