printedworks
Holder for aquarium level controller hose (and narrow gap between top glass and the sides)

Holder for aquarium level controller hose (and narrow gap between top glass and the sides)

Stefan M. · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

I designed this because on my Dennerle Nano Cube the original hose clip of my Tunze Osmolator nano didn't fit without lifting the lid.So I made a thing which needs only 5mm clearance between the top and side glass.Just press fit the hose into the holder and fix it with a cable tie.if you are frightened of the hose may fall out, you can use a drop of hot glue to keep it there.Then use the screw to fix the assembly to the aquarium glass (max. 5.5mm) Use the holder_in for 0.25in hose and the holde…

♥ 33

MyMiniFactory'da aç

Benzer modeller