Island Pig Flexi + Santa hat version

STL/3MF Multicolor Regular eyes/ 6mm eye sockets Regular/ Santa Hat 1 part (non moving head)/ 2 Part (Head and body) Print Settings: Print in Place No Supports needed Arachne walls 2-3 walls 5-10% infill Test printed to 70% YMMV *If you are having problems getting the head on the body (Two part) , set your printer bed to 65C, set the head on it for a few minutes to warm up and then pop it on. I found this easier than putting it on cold. If you have adhesion issues, try a brim, glue stick or Aqu…

♥ 1