printedworks
JGAurora A5 Manual Filament Feeding Knob and Button Setup

JGAurora A5 Manual Filament Feeding Knob and Button Setup

Devin Enrique Büchele de Montes · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial - Exclusive
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

These are some small hardware upgrades I designed for the JGAurora A5 3D Printer (Gearbest or Amazon). These quick prints will improve the extruder system my making it easier to disengage the feeding gear and manually feed filament in and out. I attached the button using 3M VHB tape There are two knob designs since my 2 A5 printers shipped with slightly different parts. The gear on the extruder has two tapped holes. If they are 135 degrees apart use V1, if they are 90 degrees apart use V2. See…

♥ 69

MyMiniFactory'da aç

Benzer modeller