printedworks
KRUSTY THE CLOWN-Simpson- musician playing drums and cymbals

KRUSTY THE CLOWN-Simpson- musician playing drums and cymbals

ViluDesigns · Cults3D

$5,00CULTS PU - Private Use
Ticari kullanım: izinli görünmüyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

automaton figure KRUSTY THE CLOWN musician playing drums and cymbals It was printed on an Ender 3 with 10% infill, a 0.2mm layer height, and supports; I used nylon thread for the hand movement. The nylon thread shouldn't be pulled tight; leave it slightly loose so the hands can move freely. I used screws and nuts to anchor the thread to the base, as shown in the images. For the connector—or base—of the long rear rod that moves the cymbals, I used a small baby hair tie; it connects the hole in t…

♥ 3

Cults3D'da aç

Benzer modeller