printedworks
Lemon Saver – Free Keeper for Cut Lemon and Lime Halves

Lemon Saver – Free Keeper for Cut Lemon and Lime Halves

Layerline · Cults3D

ÜcretsizCC BY-NC - Attribution - Non commercial

This is a lemon saver: put the cut half of a lemon or lime on the dish, push the lemon-shaped dome over it, and it stays fresh in the fridge – no cling film, no dried-out lemon. - For lemon and lime halves up to Ø 64 mm - The dome pushes over the dish's inner lip for a snug fit - Lemon outside, 45° ceiling inside – prints upright without supports This is the free basic version. The complete set is "Fruit and Vegetable Savers – Lemon, Onion, Tomato and Avocado Keepers" – you'll find it in the La…

♥ 0

Cults3D'da aç

Benzer modeller