Magazine for AEA HP Max, caliber 12.7 (.50)

The magazine is self-indexing and accommodates slugs up to 20.2 mm in length. Required for assembly: O-ring – 1.5 x 40 mm M3 countersunk-head screw (minimum total length: 17 mm) M3 rivet nut Spring wire (0.5 mm diameter), approximately 40 cm long 8 mm drill bit (for calibrating the center hole in the rotor/wheel to fit the axis) After printing the parts, remove the supports and clean any remaining material from the recesses. Use the 8 mm drill bit to calibrate the center hole in the rotor so th…

♥ 0