Minty (2) (1/8 Scale) FREE Back of Head Piece

**FREE FOR PERSONAL USE ONLY, DO NOT DISTRIBUTE/SELL** I made this using measurements from real life, this only works for **1/8**, *not 1/12* * The print scale should be in *mm* to print in **cm** (It is approximately 3cm big) * Print cavity facing *upwards* * You may need to sand the inside slots of your piece afterwards for a better fit as this new version is currently *untested*. (Will be tested soon) * You could take this into Zbrush to smart devide it smoother however the head facets will…

♥ 0