printedworks
Möbius Hoop Earrings — Twisted Ribbon, Prints Flat, No Supports

Möbius Hoop Earrings — Twisted Ribbon, Prints Flat, No Supports

Morass · Cults3D

ÜcretsizCC BY - Attribution
Ticari kullanım: izinli görünüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

A hoop earring that is a genuine Möbius band — one surface, one edge, no beginning and no end. A 6.0 × 1.2 mm ribbon is swept around a 30 mm circle while it rolls about its own axis, so the band turns face-on to edge-on and back **three times** on the way round. Worn, you look straight down the hoop's axis, and that is exactly where the twist reads: the silhouette pulses from 6 mm wide to a 1.2 mm knife edge and back, three times per hoop, and each flip catches the light from a different angle.…

♥ 0 · ↓ 6

Cults3D'da aç

Benzer modeller