printedworks
Monopoly Community Chest Card Holder

Monopoly Community Chest Card Holder

Compound 3D · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial - Exclusive
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

Monopoly Community Chest Card Holder This is a holder for the Community Chest Cards in Monopoly. It was designed for use with the cards in the standard version of Monopoly, and should fit other editions so long as the card sizes are the same. It has thumb slots on each end and a groove running down the center, length wise, to accomodate the use of a rubberband to keep the cards in the holder while not in use. Disclaimer Although I usually print at a layer height of .1mm, the card holder in the…

♥ 51

MyMiniFactory'da aç

Benzer modeller