printedworks
Montana Mask Retrofit for H600 & CPAP filters

Montana Mask Retrofit for H600 & CPAP filters

Dan Nobles · MyMiniFactory

ÜcretsizCreative Commons - Attribution - Noncommercial - ShareAlike
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

MontanaMask_CPAP_2piece_NoSupports_V1 - Print both pieces then bond the tube into the hole in the mask (Super glue should work). Push round adapter from outside of mask until it is flush with the inside surface when bonding. Model should print with no supports if positioned with flat part on bed of printer. A standard 19mm (3/4") single use CPAP bacterial filter should fit into the adapter. MontanaMask_CPAP_Retrofit_Adapter_V1 - This adapter will allow you to retrofit an original MontanaMask to…

♥ 0

MyMiniFactory'da aç

Benzer modeller