printedworks
Nozzle Holder for E3D V6 nozzles

Nozzle Holder for E3D V6 nozzles

Tom Sky · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial - Exclusive
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

I tend to buy my nozzles in batches, and I wanted a way to store them without having to read the dots and tiny embossed lettering off the side of them. This little tray holds up to 18 nozzles, in three rows, and the end is labelled 0.3, 0.4, and 0.5, which are the three sizes I use the most. The nozzle holes are 7.2mm wide, so if it's too tight, just scale up by 1-2%. The nozzles should fit snugly in the holes, and the underside is open, to allow you to pop them out easily.

♥ 26

MyMiniFactory'da aç

Benzer modeller