Omzlo PiMaster Case for Raspberry Pi 2 and 3 model B boards
Greg · MyMiniFactory
Lisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
This is a 2 part case for a Raspberry Pi with an Omzlo PiMaster HAT attached on top. It is designed to use the standoffs and screws included with the PiMaster and 4 screws M2.5x8 countersunk. 2 screw to the standoffs from the bottom on the 40 pin side and 2 screw from the top to the case to hold the cover in place (the top screws will form the threads on the printed case). No supports needed, just make sure your print settings for bridging result in clean bridges for the ports. I printed the co…
♥ 1
MyMiniFactory'da aç