printedworks
Over-the-Door Wreath Hanger – 35 / 40 / 45 mm Doors, No Supports

Over-the-Door Wreath Hanger – 35 / 40 / 45 mm Doors, No Supports

Layerline · Cults3D

$1,11CULTS PU - Private Use

This hook goes over the top of a door and holds your Christmas wreath on the outside – no nails, no tape, no holes in the door. A small star sits on the tip of the hook. - Three sizes for door thicknesses of 35, 40 and 45 mm (measure your door first) - Only 2.4 mm thick across the top of the door, so most doors still close - Width 25 mm, hook about 120 mm below the top edge of the door - J-hook with an inner radius of 9 mm for a ribbon, a wire loop or the wreath itself It prints lying on its si…

♥ 0

Cults3D'da aç

Benzer modeller