Parametric ESP32 DevKit Case - Snap-Fit Lid, No Screws, No Supports

A clean, compact enclosure for ESP32 DevKit boards (30 and 38 pin). The board rests on two end ledges so the header pins stay free underneath, and the snap-fit lid holds it in place. No screws, no glue. **Features** - USB opening on the short side - Ventilated lid with posts that hold the board down - Prints flat without supports - Fully parametric OpenSCAD file included: change board size, wall thickness, height and USB opening in the Customizer Boards vary slightly between manufacturers: meas…

♥ 0