printedworks
Protective Wire Guide Bracket

Protective Wire Guide Bracket

printomatic · Cults3D

ÜcretsizCC0 - Creative Commons public domain
Ticari kullanım: izinli görünüyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This is a very simple protective wire-guide bracket is intended to allow a wire to pass over the edge of a roof or awning without rubbing or chafing. A through-hole enables a zip-tie to "lock" the wire into the guide tube. **If you use these outdoors, make sure you print them out of PETG or some other weather-resistant filament.** This wire guide uses no special slicer settings and can be printed without supports. There are 3 variations included; the regular standoff, a slightly shorter version…

♥ 0

Cults3D'da aç

Benzer modeller