Pumpkin Place Card Holder - Two Aligned Card Notches

Most printed place card holders use a single slot in the middle, and a card wider than about 60 mm tips forward out of it. This one holds the card at two points instead: two 2.5 mm notches cut into the top edge of the base, set 60 mm apart, so the card is supported near both ends and stands square. Between them sits a 45 mm pumpkin, pierced by three straight slots that read as the ribs. The whole thing is one solid piece: the front silhouette is extruded 18 mm deep, which is what makes it heavy…

♥ 0