printedworks
reverse bowden for Prusa MK3 and Zaribo on IKEA Lack enclosure

reverse bowden for Prusa MK3 and Zaribo on IKEA Lack enclosure

Stefan M. · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This is a reverse bowden setup for the Prusa MK3 or Zaribo extruder in an IKEA Lack enclosure. I used 2 M6 4mm Fittings and a 2mm/4mm PTFE tube. You need to drill a hole close to the spool holder through the table.Then put the cylinder on it from the outside and the printed tube through the hole in the cylinder and the table and secure it from the inside of the enclosure with the printed nut. After this screw one fitting from the inside into the cap of the cylinder and the other one in the fila…

♥ 5

MyMiniFactory'da aç

Benzer modeller