printedworks
Rogue One Rebel 1 piece Torch

Rogue One Rebel 1 piece Torch

Theren Williams · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial - Exclusive
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

Built to hold a small torch inside. The internal diameter is 15.2mm and the lenght is 98mm it was designed to fit the torch in the link below but any torch that has a diameter of 15mm and around 98-100mm long will work, if it has a rear push button activation. 1-1.2 mm diameter wire is needed to make the bracket to hold the torch to the shield. If you glue the main body into the 3d print you can screw the rear on to the main body allowing you to change the battery. Some sanding may be required…

♥ 10

MyMiniFactory'da aç

Benzer modeller