Sh-Elf SPLIT Male

Sh-Elf SPLIT Male I know it was super hard deciding on colours if you only had a 4 colour printer. So here is the Sh-Elf Male version split. Each part has no more than 4 colours. It does now require some glue, and some minimal supports. set top z to 0.275 is my preferred setting. You will notice some subtle differences in the design compared to the full multi colour version. 0.2 layer, 15% infill Filaments used as before, Bambu Basic, mistletoe green, red, white, gold, black, beige and brown

♥ 1