printedworks
Ship's-Wheel Earring — Free-Spinning, Print-in-Place

Ship's-Wheel Earring — Free-Spinning, Print-in-Place

Morass · Cults3D

ÜcretsizCC BY - Attribution
Ticari kullanım: izinli görünüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

A tiny ship's wheel (helm) that really spins. It prints as a single print-in-place job — the eight-handled wheel comes off the bed already captured on a fixed axle, riding between a bearing foot below and a retainer cap above, so it turns freely the moment you pop it loose. No assembly, no jump-ring joint to the wheel, no supports. The trick is orientation: the axle stands vertical (+Z) so the wheel prints flat on the bed and every wheel-to-frame face is a clean horizontal gap (0.45 mm). That s…

♥ 1 · ↓ 4

Cults3D'da aç

Benzer modeller