printedworks
Simple Anet A8 Anti Z Wobble

Simple Anet A8 Anti Z Wobble

Jérôme Pirotte · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

The Z Axis threaded rod for the Anet A8 is too short to reach all the way to the frame, resulting in z wobble. I made this very simple object to press fit to the top of the rods to extend them enough to reach the holes in the frame. To install it, just remove the top plate. You might need to adjust the rod position at the bottom of the motor. Hope you like it. Feel free to leave any suggestions.

♥ 16

MyMiniFactory'da aç

Benzer modeller