printedworks
Snapmaker BoogerHooks

Snapmaker BoogerHooks

Marius Oosthuizen · MyMiniFactory

ÜcretsizCreative Commons - Attribution - Noncommercial - ShareAlike
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

That little piece of filament the printer extrudes before printing, then dangling off the front corner of the build plate has always irritated me a bit. Since there is nothing to grab hold of it or bump into it to knock it loose, I made these hooks to clip in between the display and the y-axis to do that job. I've had fairly mixed results regarding the time it takes to dislodge that little filament booger (not sure what else to call it), but the results are always the same - it will be knocked/…

♥ 10

MyMiniFactory'da aç

Benzer modeller