printedworks
Snowball Makers – Clam Tongs for 5, 6 and 7.5 cm Snowballs

Snowball Makers – Clam Tongs for 5, 6 and 7.5 cm Snowballs

Layerline · Cults3D

$2,22CULTS PU - Private Use
Ticari kullanım: izinli görünmüyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This is a set of snowball makers in three sizes: scoop up snow with one half, close the tongs and squeeze – out comes a round snowball, every time, without cold hands. The two halves are deep side plates that lie on top of each other when closed and make a solid grip; small holes let air and melt water out. - Snowballs of 5, 6 and 7.5 cm - 5 and 6 cm: both halves and the pin on one plate; 7.5 cm: three files (fits a 220 mm bed) - Each half prints with its grip edge on the bed and the cup open t…

♥ 0

Cults3D'da aç

Benzer modeller