Soldering tip block 100 mm - 6 blind round wells 7 mm, for COLD tips only

Bench block, 100 x 52 mm and 18 mm tall, cut by six BLIND round wells of 7 mm at 15 mm pitch, 14 mm deep. - 9 mm of solid block at each end, 4 mm of solid floor under all six -- one piece, six wells, one file, not a set of six - MEASURED ON THE MESH: six wells at 14 mm depth, zero openings below the floor - A common soldering tip is 4 to 6.5 mm across the body: it goes in point up or point down and rests on the floor of its well READ THIS BEFORE PRINTING: THE TIPS MUST BE COLD. PLA softens arou…

♥ 0