printedworks
Spider logo iron-on

Spider logo iron-on

Juyix · Cults3D

ÜcretsizCULTS CU - Commercial Use
Ticari kullanım: izinli görünüyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

It’s super easy to apply. Just follow these steps: Print: Use the template I’ve already prepared. I set the thickness to 0.32 mm because that’s the ideal thickness: it holds up well but stays flexible. Position: Place the piece flat on your T-shirt (I recommend using 100% cotton or a cotton blend). Protect: Cover the entire design with wax paper (baking paper). Iron: Set the iron to high heat with no steam. Apply firm pressure over the transfer for about 10 to 15 seconds. Check: Let it cool for…

♥ 2 · ↓ 12

Cults3D'da aç

Benzer modeller