Tatting Shuttle with Picot Pick - Two-Part Post Shuttle for Lace Tatting, Customizable (No Supports)

A post shuttle for shuttle tatting. Wind the thread round the centre post; the tips close on the thread so it only pays out when you pull it. Half A has a flat pick on one end for picots and joins. WHY IT IS TWO HALVES A one-piece shuttle has a gap between its plates that cannot be printed without support. So each half prints flat, outer face down, and the halves press together on a peg in the centre post (a drop of glue makes it permanent). THE TIPS MEET BY DESIGN The inside face of each plate…

♥ 0