printedworks
Taulman3D Small Spool Holder

Taulman3D Small Spool Holder

Jason Kelly · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial - Exclusive
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

If you have purchased nylon from Taulman3D you might have run into the same problem I had, the spool is much smaller than most. So to fix that I modeled this 1" bolt and nut to go though my existing spool holder. It works really well and is easy to store with the nylon spools. This can be printed with out supports, they only defect you might see is the floor of the hex feature. Depending on your printers bridging ablites it might look a little off.

♥ 1

MyMiniFactory'da aç

Benzer modeller