Test block B
Dave Penn · MyMiniFactory
ÜcretsizCreative Commons - Attribution Alone
Test Block 2 A simple geometric test block i use to test Extrusion/Heat/Overhang Ratio along side ironing.Also give's a good idea of resolution over curve's and angle's. Approx 30mm x 30mm x 20mm. If calibrated properly will give nice clean sharp edges and smooth to surface. If calibrated poorly.. Droop's on lower side sphere = Too hot or Over ExtrusionLoss of definition at top of triangle = Too cold/ Under ExtrusionUneven/patchy top surface = Under Extrusion Probably...Lump on Far side square…
♥ 0
MyMiniFactory'da açBenzer modeller
Hole Error Test Plate, 5 to 22 mm
Printables
Snapmaker U1 full spectrum color test
Printables
Filament Swatch Holder – 51 Color Organizer + Filament Test Tile - Gridfinity
Printables
Contenitore test card V4 x50 slots
Printables
Compact tolerance test
Thingiverse
Test
Thingiverse
2-in-1 AMS Test and Color Bleed Test
Thingiverse
Cubehole: A 3D printer test
Thingiverse
Shrinkage Test Print
Thingiverse
/https://fbi.cults3d.com/uploaders/40900900/illustration-file/91cff1d5-e62e-4385-8991-99882f3bf2fb/NGE_-_EVA_1.gif)
EVA 1 - Neon Genesis Evangelion - Coaster and Display Piece
Cults3D
test
Printables
12-24V Test light holder
Thingiverse