printedworks
UFO-Turbine engine

UFO-Turbine engine

Marco Cammozzo · MyMiniFactory

ÜcretsizDownload - Share - Maintain License - Credit - Remix - Noncommercial
Lisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

This engine, called UFO because of its strange shape is based around an impeller and can reach interesting speeds and powers for small purposes.I designed it to power a tank, but i managed to build the tank too big for this one, so i'm going to design a bigger and newer one for that purpose.You'll only need 5 M3 screws and nuts to close the back and an M4 long at least 40mm to act as the shaft. The bearings are 13mm in diameter, 5mm height and 4mm inner diameter.Built with some patience runs su…

♥ 88

MyMiniFactory'da aç

Benzer modeller