/https://fbi.cults3d.com/uploaders/37129704/illustration-file/b0e126ad-b113-41b9-8c09-53438e1311dd/Engine.jpg)
Velocity stacks for YAMAHA R1 bikecarb
matespetran · Cults3D
Ticari kullanım: izinli görünmüyorLisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
These velocity stacks are designed for the Yamaha R1 carburetor. They have been modified to fit 62mm Ramair air filters. The parts are 3D-printed from ASA material and have held up for three months so far. You will receive two models. One model measures 43 mm from the end of the carburetor, and the other 65 mm. Both have an outer diameter of 70 mm. For a proper seal, I recommend wrapping electrical tape around the joint between the velocity stack and the carburetor and securing it with a hose c…
♥ 1
Cults3D'da açBenzer modeller
Velocity Stack for 120mm PC Fan
Thingiverse
velocity stack for 5015 radial fans
Printables
Velocity stack for Noctua 40mm fan NF-A4x10
Thingiverse
Velocity Stack for MinionD dual duct
Thingiverse
Velocity Stack for 30mm Fan
Thingiverse
Velocity Stack for 30mm Fan
Thingiverse
Velocity Stack for Semto ST-NF2
Thingiverse
Velocity Stack for 40mm fan
Thingiverse
Velocity Stack and Fan Guard for 40mm Fan (round)
Thingiverse
Velocity Stack and Fan Guard for 40mm Fan (flat side)
Thingiverse
Velocity Stack with Centre for 30mm fan
Thingiverse
Velocity Stack and Fan Guard for 30mm Fan
Thingiverse