Winterland Moose Flexi

STL/3MF Multicolor Regular eyes/ 6mm eye sockets 1 part (non moving head)/ 2 Part (Head and body) Antlered (glue them in slots)/ Non Antlered versions Print Settings: Print in Place No Supports needed Arachne walls 2-3 walls 5-10% infill Tested down to 70%, YMMV *If you are having problems getting the head on the body (Two part) , set your printer bed to 65C, set the head on it for a few minutes to warm up and then pop it on. I found this easier than putting it on cold. If you have adhesion iss…

♥ 1