Wire Hole Plug and Cover
JB · MyMiniFactory
Ticari kullanım: izinli görünmüyor · Atıf istiyorLisans bilgisi ve sorumluluk reddi
Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin MyMiniFactory sayfasındaki lisans ve tasarımcının kendi şartlarıdır.
Installed some pot lights in my wardrobe the other day and was left with some unsightly holes I had drilled to route the wires. Inspired by the cable hole plugs on my desk, I drew up this two-part hole plug and cover to plug the holes and give it a cleaner, less obvious look. This is designed for 26mm diameter holes, but can be scaled up/down to fit other sizes. The holes were drilled into the backboard of my wardrobe which is about 3mm thick. This is the thickness of everyone's favorite Swedis…
♥ 13
MyMiniFactory'da açBenzer modeller

HF Wire Lever Switch 2020 Mount
Printables

2020 Extrusion Cable Clip
Printables

Gridfinity - Bin 1.2.12 - Wire spool holder
Thingiverse

Gridfinity - Bin 1.1.6 - Wire spool holder
Thingiverse

Wire Grid Shelf with Slot for Glass Slide
Thingiverse

Cable clip for three 6 mm cables, M3 screw
Sketchfab

24mm Conduit Clamp, Cable Clip Holder | Free STL
Sketchfab

Mains Hard Wire Kit for SV08 Max
Printables

Runout Sensor Wire Plug
Printables

Solder Wire Spool Holder with Tray
Thingiverse

Wire & Solder Spool Rack
Thingiverse

Small Wire Looms with snap on caps that I made when running speaker wires for an 8 speaker system in a pavilion. They worked out great as you can screw these in place and then run all your wires and snap them into place
Thingiverse