/https://fbi.cults3d.com/uploaders/16168828/illustration-file/bbdd63b0-e2d0-452b-ad53-6d14b5281d72/IMG_3208.jpg)
Witch with a Broom and Wand — Halloween Display Figure
Marlboro · Cults3D
$0,56CULTS PU - Private Use
A tall witch mid-stride on a round plinth, one arm out with a wand, the other trailing a bundled twig broom, and a long cloak caught in the wind behind her so it sweeps out in one big sail of fabric. She wears a wide-brimmed pointed hat with a buckled band, a laced bodice and boots, and the ground around her feet is scattered with rocks and a small pumpkin. The cloak is the piece — it's thin, it flows, and it gives the whole figure movement from any angle. A proper display sculpture rather than…
♥ 0
Cults3D'da açBenzer modeller

Knitting Needle and Crochet Hook Gauge - 2 to 10 mm Sizer with Ruler and Swatch Window, No Supports (OpenSCAD)
Printables

do not print with supports!
Printables

CYD 2.8 Case with stylus holder - No screws
Printables

3D Stereoscope with adjustable mirrors
Printables

Minimalist PCB Klicky Dock Front Insert with Extra Magnet for Duender
Printables

MMX Robusta (MMX remix with extras)
Printables

AD5X Poop Slide with raised edge
Printables

Compact 5-port Filament hub with filament sensor for MMU
Printables

PolyDryer/SnapDryer wall mount with Sy's Peglock system
Printables

VZBOT 330 AWD Long shaft motors mount with F625 ZZ
Printables

Prusa Core One INDX multicolor filament plates with numbers
Printables

Ender - Strain Relief for Watercooled Hot End Upgrade with BLTouch
Printables