printedworks
T-Splitter 90 mm with 60 mm branch

T-Splitter 90 mm with 60 mm branch

AMPERELAB3D · Cults3D

$1,11CULTS PU - Private Use
Ticari kullanım: izinli görünmüyorLisans bilgisi ve sorumluluk reddi

Bu özet, kaynak sitedeki lisans adından otomatik çıkarılır; hatalı ya da eksik olabilir ve hukuki tavsiye değildir. PrintedWorks modelleri barındırmaz, lisans vermez ve lisansın doğruluğu ya da modelin kullanımı konusunda hiçbir sorumluluk kabul etmez. Kullanım koşulları için tek geçerli kaynak, modelin Cults3D sayfasındaki lisans ve tasarımcının kendi şartlarıdır.

T-piece for warm air ducting. The 90 mm run continues straight through, the 60 mm branch leaves at a right angle. **Use a T where a Y will not fit.** A right angle costs more pressure than a 45 degree Y. Take the T when the branch has to leave sideways in a tight bay, and the Y everywhere else. The crotch is radiused 6.0 mm / 3.6 mm. Where two ducts of equal size meet at a right angle their outer surfaces touch at two points, and no larger radius fits there geometrically. The flow-relevant inne…

♥ 0

Cults3D'da aç

Benzer modeller